MOT 2013 fail

Well, the usually helpful and undemanding local garage is bit more fussy this year:
1) marker lights at the front on top of the cab and the camper ! I didn't think those were needed, just decoration, but apparently not,
2) front brake pads, well they looked OK to me and after 2000 miles they won't be much different to last year, but I guess it won't do much harm to replace them.
3) The steering column moves up and down. Just like it did last year in fact. This I have to admit should have had some attention before. A brief inspection leaves me largely clueless about what is supposed to hold it in place. A complete dismantle may be required ...


It is secure against sideways movement. And I suspect that it s a mix of 4x2 and 4x4 parts that don't quite fit together. Not to mention what happened when the cab was replaced a few years ago. Then again maybe a circlip is missing, shown in the parts catalogue but not in the workshop manual.

As an experiment I'll try uploading an XPS file << failed. here is jpg conversion>>:



And the parts list:

Iveco 2003/2-13214124 | 40-104X4 NEW DAILY | 501300 6216935
   
ITM   PART N.  QT DESCRIPTION             NOTE
001    4329212 02 RUBBER BUSH 
002    8593362 01 STEERING UN.JOINT 
003   93813424 01 STEERING BEARING 
004    8594632 01 STEERING SPINDLE        ASSY 
005    8965572 01 CLIP                           L=180 MM 
006   10516471 01 SPRING WASHER           DIAM=6 MM 
007   10516671 01 SPRING WASHER           DIAM=8X14,8 SP=2,2 MM 
008   10519601 01 WASHER                  DIAM=8X17 MM 
009   10791411 01 HEXAGON NUT             M16X1,5 
010   10902421 01 HEXAGON BOLT            M6X20 MM 
011   11066976 01 CIRCLIP                    DIAM=19,5 MM 
012   12644401 01 WASHER                  DIAM=6,15 MM 
013   12646701 01 WASHER                  DIAM=8X20 MM 
014   13402275 01 CIRCLIP 
015   15691601 01 CUTTING SCREW 
016   16043521 01 HEXAGON BOLT            M8X22 MM 
017   16043833 01 HEXAGON BOLT            M8X1,25X30 MM 
018   16100811 01 HEXAGON NUT             M8 
019   16104121 01 HEXAGON NUT             M8 
020   93802648 03 SUPPORT RING 
021   93802711 01 PROTECTIVE HOOD                                 Modified 
022   93803271 01 PIN 
023   93803272 01 SPRING                      DIAM=10,5X21 MM 
024   93803474 01 BUSH 
025   93803478 02 COVER 
026   93804882 01 PROTECTIVE HOOD 
027   93805649 02 CONNECTING PLATE 
028   16044034 04 HEXAGON BOLT            M8X1,25X40 MM 
029   93808243 02 RING 
030   93808245 02 SUPPORT 
031   93808249 01 STEERING BEARINGS 
032   93809996 01 COVER 
033   93811178 01 BUSH 
034   93811280 01 STEERING WHEEL          ASSY 
035   93812776 01 STEERING SPINDLE        ASSY 
036   93811185 01 BUSH 
037   93813870 01 PROTECTIVE HOOD                                 Modified 
**************************************************************************


Perhaps I just need a circlip  ;)




Comments

Post a Comment

Popular posts from this blog

Fuel tank

Image
The original daily had a fuel tank of about 60ltr I needed to extend the range (we do about 20mpg) and wanted to stay with Iveco parts as much as possible. So chose a tank from a 7.5 Eurocargo from a scrap yard for £40. collecting the tank: new straps painted and ready to assemble: In place on the Tardis: best decision staying with Iveco, all the electrics and fixings worked easily... worst decision picking a tank without a locking fuel cap We can now do over 1000 km without filling up, enough to drive all through Spain on Moroccan fuel at 60p a ltr.
Read more

Alternator upgrade

Image
Alternator failed again (lasted 5 years). Did some research and got a lot of help from Grahame on an upgrade to a 90Amp version (from 55Amp). Note that the Sterling B2B is rated at 50Amp so it could be drawing power at the alternator maximum for long periods. That should not be so serious now that I have 280W solar as well. Alternator model: Lucas LRB197 (Bosc 0986035770) Needs longer brackets  - 40mm longer, obtained by buying two new ones (Vexi were selling them for £2.55 to clear stock). Welded beautiful by Lee at work. Two different part numbers for alternator bracket. Mine was 99449305   Longer fan belt 10 x 950mm All in place Issues: It was to awkward to put in a bigger cable from alternator to the starter motor (main battery connection). I may do a separate longer cable back to the battery. The ignition light does not come on until the alternator is energized by the revs going up to 1500. People say this is not a problem. A potential fix is to put...
Read more

Cold Start system Thermostarter

Image
November 2020 Update See notes further down for the latest. The Iveco has a cold start system, or so I thought. But the pattern of flashing lights when I started was not the pre heater, but an error code. The cold start system was not connected. It is now. Our engines don't have glow plugs. Instead there is a single preheater that heats up some diesel fuel and squirts it into the air inlet. It works below zero. The unit does so diagnostic tests and flashes the pre heat light to show the outcome. Normally the light goes on for a couple of seconds and then off. The electronic manual on Ivecodaily4x4@groups.io posted by Hugo has an invaluable diagnostic guide. There is a module behind the fuse box that takes the signals in and send power to the preheater. In my case the main power cable was missing. Also the crucial temperature sensor was faulty. A new one solved the problem. No error codes now. Iveco Daily Genuine Iveco Coolant Temperature Sensor Part No.4857248 5010293265 £18 from V...
Read more